EMAT Thickness Gauge

EMAT Thickness Gauge UT-04 EMA (Delta)

Thickness measurements of metals:

air gap up to 3 mm
no couplant
through paint&protective coating up to 3 mm
tested surface temperature range from -40°C to +650°C
error below 0.1 mm
range of measured thicknesses
from 1.0 to 400.0 mm (steel)
from 1.0 to 200.0 mm (aluminum)
high precision mode (0.01 mm)
measurements under water
measurements of corroded surfaces
measurements of curved surfaces
strictly 90° not requirred

A-scan mode
B-scan mode - thickness profile chart of the tested object
special transducers for:
- pipes
- hot surfaces

EMAT Thickness Gauge UT-04 EMA (Delta) has Certificates of Conformity with the following European Directives:

Low Voltage Directive 2014/35/EU

Electromagnetic Compatibility Directive 2014/30/EU

EMAT Thickness Gauge UT-04 EMA (Delta) enables reduction of time and cost by a several fold factors that is especially important for measurment in restricted zones such us nonoccupied area of nuclear power plant.

In the end of 2017 special modification of EMAT thickness gauge for continuous measurements up to 500°C was developed and successfully tested by Special Scientific Engineering http://www.snr-ndt.com/ and Delta Test https://deltatest.de/.

Two types of probes for measurements of hot surfaces with air-cooling:

Manual

Roller carriage with B-scanner, thickness measurements and profile chart drawing simultaneously. *successfull common development of Special Scientific Engineering http://www.snr-ndt.com/ and Delta Test https://deltatest.de/.

Fast in-line scanning of hot surfaces (up to 500°C, continuously) is available with a new EMAT transducer with air-cooling. Results of scanning can be exported as a chart, excel file or any supporting format to PC or laptop. *successfull common development of Special Scientific Engineering http://www.snr-ndt.com/ and Delta Test https://deltatest.de/.